March 24th, 2006, 01:12 PM
|
|||
|
|||
|
Noob question..scratched graphite shaft
Hi all,
I was regripping my cobra F speed driver today. When I cut the old grip off, I was a bit careless and cut a 2 inch long scratch in the graphite, about where my lower hand would be on the grip. I didn't cut deeply..just enough to see thru the color of the graphite. Will this scratch hurt anything, or will the grip tape seal it ok ?...hoping it's only cosmetic. 
|
| REGISTER and browse with less advertisements! It's FREE! |
|
March 24th, 2006, 08:18 PM
|
|||
|
|||
|
It's really hard to say without seeing the scratch. You could fill the scratch in with clear nail polish or a thin layer of 5 minute epoxy. Just be sure to wipe off all the excess epoxy. You just want to leave the epoxy inside the scratch. Next time, buy yourself a pack of hook blades. They only cost about a buck or two for a pack of five. You'll be pulling the grip away as you cut and wont have to worry about scratching the shaft.
|
 |
| Tags: graphite, noob, questionscratched, shaft |
«
Winn Grips
|
Regrip Tools
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Scratched up my new driver...help | nathansdad04 | Club Making & Repair | 15 | October 3rd, 2006 10:52 PM |
| Graphite Shaft Question | Milehigh | Club Making & Repair | 9 | September 17th, 2006 06:56 PM |
| noob shaft qeustion.... | slayer544 | Golf Equipment | 5 | May 10th, 2006 04:48 PM |
All times are GMT -4. The time now is 10:51 PM.
