November 16th, 2006, 10:16 PM
|
|||
|
|||
|
"Pulled shaft" prep?
I have a like new pulled graphite shaft that still has a small amount a dried epoxy on it. Can I just rough it up some and reinstall or is there more to the prep than that?
Thanks... 
|
| REGISTER and browse with less advertisements! It's FREE! |
|
November 16th, 2006, 10:30 PM
|
||||
|
||||
|
Quote:
As long as the shaft still fits in the hosel, you can rough up the small amount of epoxy and install. It is not necessary to remove 100% of the old epoxy, which may lead to excess sanding and compromising the shafts integrity.
|
|
November 17th, 2006, 01:59 AM
|
|||
|
|||
|
AGWSA is right! You need to rough it up to make sure it fits in the hosel and for better gripping when installed. But I would make sure you sand as much epoxy off the tip as possible.
|
 |
| Tags: prep, quotpulled, shaftquot |
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Girlfriend out of town" = "Bedford plays golf" | dbwilder | General Golf Discussion | 14 | August 11th, 2006 09:38 AM |
| Royal Precision "Spinner" Wedge Shaft | DUFFY | Golf Equipment | 4 | July 10th, 2006 09:34 AM |
| AccuFLEX News- "Official Shaft of Hooters tour" | accuflex | AccuFLEX Golf Shafts | 2 | May 28th, 2006 10:20 AM |
| "Reviews" forum changed to "Golf Equipment" | victory | Announcements/Help Desk | 3 | June 9th, 2004 08:46 AM |
All times are GMT -4. The time now is 10:14 PM.
