March 12th, 2008, 07:40 AM
|
||||
|
||||
|
PING iron shaft bore size
Here's a question I should know the answer to... If anyone knows of the top of their head; Did PING use .355" taper or .370" parallel shafts on the Eye2's? I could dig out my calipers, but this might be easier.
I want to stick a UST ProForce Rv2 95 in my 2-iron, but I can only find them in .370" tip. 
|
| REGISTER and browse with less advertisements! It's FREE! |
|
March 12th, 2008, 12:29 PM
|
||||
|
||||
|
Re: PING iron shaft bore size
Don't hold me to this Martini, but I'm thinking I read that all Ping irons since the early 80's are .370". There's a guide you can download on the Golfsmith website (Acrobat format) that should say for sure.
|
|
March 13th, 2008, 12:46 AM
|
||||
|
||||
|
Re: PING iron shaft bore size
I'm thinking they are .370" also. Even if they are .355" taper, I'm sure the .355" existing hole would make a pretty good "pilot" hole for a .370" drill press.
|
|
March 13th, 2008, 11:41 AM
|
|||
|
|||
|
Re: PING iron shaft bore size
I'm with you on that. If they are 355" I'd drill them out to .370" and not worry about it. Much more shaft choices at .370". so why not drill them out? I got a good deal on a pair of wedge head with 355 hosels, and I drilled them out as soon as I got them. It's easy to do, and it saves a lot of trouble in the long run.
|
 |
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| thru bore shaft grinding | mattyboy | Club Making & Repair | 3 | February 23rd, 2007 02:00 PM |
| Bore-Thru's Affect on Shaft Torque | glfrjack | Club Making & Repair | 3 | January 12th, 2007 06:28 PM |
| replacing a bore through shaft | jfb | Club Making & Repair | 13 | January 23rd, 2006 07:42 PM |
All times are GMT -4. The time now is 10:18 PM.
